![]() You may tap various places on the screen or you may drag around the cursor should follow in either case. The target will move to the upper right corner touch and release the target.The target will move to the lower right corner touch and release the target.Wait for the target to appear (as below), then touch and release the target.Click the Calibrate Touch Screens buttonMulti-touch driver (6.9 ) or the Align button Single touch driver ( 6.0).The EloVa program will continue until all controllers and/or ports have been calibrated Press the Esc key on the keyboard to terminate or skip calibration for any monitor, or you can also allow the program to time out (as indicated by the progress bar). ![]() When EloVa runs for the first time, it will attempt to calibrate all controllers and/or serial ports that were installed.If the cursor does not appear at the position touched, click the blue curved arrow and the calibration program will run again. If the cursor appears at the position touched, click the green arrow to accept and exit out of the calibration program. You will then be asked to touch various points on the screen to verify that the cursor appears at the position touched.6) When you run EloVA using one of the above options, touch each of the three targets as they appear on the screen.5) By running EloVa.exe directly from the Windows command line or \Windows\System32 directory.The Elo Touchscreen Control panel will appear. 4) Double-click the Elo icon on the system tray. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |